Technical information
Danfoss OMR X type semi-rapid motor
Danfoss reference: 11185549
Displacement: 160 cm3
SAEA 2-hole flange - centering 82.5 mm
Cylindrical shaft diameter 1 inch
Offset side holes Ø G 1/2
Drain size: G 1/4
Standard dust cover gasket
Maximum pressure on the shaft seal = 225 bar
Front bearing = Fluid bearing
Rear bearing = Fluid bearing
Integrated drainage check valves
Key 1/4 x 1/4 x 1 1/4 inch (B.S. 46)
Danfoss reference: 11185549
Displacement: 160 cm3
SAEA 2-hole flange - centering 82.5 mm
Cylindrical shaft diameter 1 inch
Offset side holes Ø G 1/2
Drain size: G 1/4
Standard dust cover gasket
Maximum pressure on the shaft seal = 225 bar
Front bearing = Fluid bearing
Rear bearing = Fluid bearing
Integrated drainage check valves
Key 1/4 x 1/4 x 1 1/4 inch (B.S. 46)
Technical data
| Motor type | OMR Geroller |  |
|
| Displacement | 160 | cc/rev | |
| Flange type | SAE A flange |  |
|
| Shaft type | Cylindrical |  |
|
| Size of the shaft | 25.4 mm (1") | ||
| Orifices position | Side port - Offset |  |
|
| Orifices A & B size | G1/2 | ||
| Taille du drain | G1/4 | ||
| Shaft seal | Int. in shaft seal 225 bar | ||
| Bearing type | Journal bearing | ||
| Speed sensor | No | ||
| Paint | Not paint | ||
| Marque | Danfoss / White WDMS |  |